Dumps Moneyack Guarantee - 500-220 Dumps UpTo 50% Off
Updated Apr-2023 Pass 500-220 Exam - Real Practice Test Questions
Cisco 500-220 Exam Certification Details:
| Sample Questions | Cisco 500-220 Sample Questions |
| Number of Questions | 55-65 |
| Exam Registration | PEARSON VUE |
| Recommended Training | Engineering Cisco Meraki Solutions Part 1 (ECMS1) Engineering Cisco Meraki Solutions Part 2 (ECMS2) |
| Duration | 90 minutes |
NEW QUESTION 15
Which two primary metrics does Meraki Insight use to calculate the Application Performance Score? (Choose two.)
- A. Maximum Jitter
- B. Maximum Latency
- C. Per-flow Goodput
- D. Total Bandwidth Usage
- E. Application Response Time
Answer: C,E
NEW QUESTION 16
Drag and drop the settings from the left into the boxes on the right to indicate if the setting will be cloned or not cloned using the Cisco Meraki MS switch cloning feature.
Answer:
Explanation:
NEW QUESTION 17
Which information do the MXs in a High Availability pair share?
- A. time synchronization state
- B. DHCP association database
- C. spanning-tree state
- D. stateful firewall database
Answer: C
NEW QUESTION 18
Which Cisco Meraki best practice method preserves complete historical network event logs?
- A. Configuring the preserved event number to maximize logging.
- B. Configuring the preserved event period to unlimited.
- C. Configuring Dashboard logging to preserve only certain event types.
- D. Configuring a syslog server for the network.
Answer: A
NEW QUESTION 19
Which two actions can extend the video retention of a Cisco Meraki MV Smart Camera? (Choose two.)
- A. enabling audio compression
- B. enabling maximum retention limit
- C. enabling motion-based retention
- D. configuring a recording schedule
- E. installing an SSD memory extension
Answer: C,D
NEW QUESTION 20
Refer to the exhibit.
Which IDS/IPS mode is the MX Security Appliance configured for?
- A. quarantine
- B. detection
- C. prevention
- D. blocking
Answer: C
NEW QUESTION 21
Refer to the exhibit.
What is an advantage of implementing inter-VLAN routing on an MX Security Appliance rather than performing inter-VLAN routing on an MS Series Switch?
- A. The MX appliance performs data encryption for inter-VLAN traffic.
- B. The MX appliance performs AMP for inter-VLAN traffic.
- C. The MX appliance performs IDS/IPS for inter-VLAN traffic.
- D. The MX appliance performs content filtering for inter-VLAN traffic.
Answer: A
NEW QUESTION 22
Refer to the exhibit.
Which design recommendation should be considered?
- A. A 25-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 2-hop maximum.
- B. A 50-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 2-hop maximum.
- C. A 50-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 1-hop maximum.
- D. A 25-percent throughput loss occurs for every hop. Cisco Meraki best practice recommends a 1-hop maximum.
Answer: D
NEW QUESTION 23
Refer to the exhibit.
Which outcome occurs when logging is set to Enabled?
- A. The hits counter within this section is now enabled.
- B. Outbound flows are sent to a configured syslog server if a syslog sender is configured for flows.
- C. Inbound flows are sent to a configured syslog server if a syslog server configured for flows.
- D. This firewall rule is now enabled.
Answer: C
NEW QUESTION 24
When an SSID is configured with Sign-On Splash page enabled, which two settings must be configured for unauthenticated clients to have full network access and not be allow listed? (Choose two.)
- A. Simultaneous logins
- B. Controller disconnection behavior
- C. Captive Portal strength
- D. RADIUS for splash page settings
- E. Firewall & traffic shaping
Answer: B,C
NEW QUESTION 25
What is a feature of distributed Layer 3 roaming?
- A. An MX Security Appliance is not required as a concentrator.
- B. All wireless client traffic is tunneled.
- C. An MX Security Appliance is required as a concentrator.
- D. All wireless client traffic can be split-tunneled.
Answer: A
Explanation:
Reference:
Cisco_Meraki_Best_Practice_Design/Best_Practice_Design_-_MR_Wireless/
Wireless_Layer_3_Roaming_Best_Practices
NEW QUESTION 26
How does a Meraki device behave if cloud connectivity is temporarily lost?
- A. The offline device stops passing traffic.
- B. The offline device continues to run with its last known configuration until cloud connectivity is restored.
- C. The offline device reboots every 5 minutes until connection is restored.
- D. The offline device tries to form a connection with a local backup sever.
Answer: D
NEW QUESTION 27
Refer to the exhibit.
A packet arrives on the VPN concentrator with source IP 10.168.70.3 and destined for IP 10.116.32.4.
What is the next hop for the packet, based on this concentrator routing table?
- A. The packet is stopped.
- B. Not enough detail is available to determine the next hop.
- C. The Auto VPN peer "Store 1532 - appliance" is the next hop.
- D. The concentrator gateway (10.128.124.62) is the next hop.
Answer: B
NEW QUESTION 28
Which Cisco Meraki product must be deployed in addition to Systems Manager so that Systems Manager Sentry enrollment can be used?
- A. Meraki Insight
- B. MV Smart Camera
- C. MR Access Point
- D. MS Switch
Answer: C
NEW QUESTION 29
Refer to the exhibit.
Which two actions are required to optimize load balancing asymmetrically with a 4:1 ratio between links? (Choose two.)
- A. Enable load balancing.
- B. Change the assigned speeds of WAN 1 and WAN 2 so that the ratio is 4:1.
- C. Set the speed of the cellular uplink to zero.
- D. Change the primary uplink to "none".
- E. Add an internet traffic preference that defines the load-balancing ratio as 4:1.
Answer: A,E
NEW QUESTION 30
Refer to the exhibit.
During a Meraki AP deployment, the default SSID that the exhibit shows is broadcast. What causes this behavior?
- A. An AP has Site Survey mode enabled.
- B. An AP does not have a wired connection to the network.
- C. An AP cannot connect to the default gateway.
- D. An AP has never connected to the Meraki Cloud Controller.
Answer: D
Explanation:
Reference:
Troubleshooting_local_connection_issues_using_default_SSID_on_MR_Access_Points
NEW QUESTION 31
Refer to the exhibit.
What are the Loss and Average Latency statistics based on?
- A. responses that the MX appliance receives on the connectivity-testing hostnames on the Insight > Web App Health page
- B. responses that the MX appliance receives on the connectivity-testing IP address that is configured on the Security & SD-WAN > SD-WAN & Traffic Shaping page
- C. responses that the MX appliance receives on the connectivity-testing IP addresses on the Security & SD- WAN > Firewall page
- D. responses that the MX appliance receives on the connectivity-testing IP addresses on the Help > Firewall info page
Answer: C
NEW QUESTION 32
Which configuration step is necessary when automatic updating is required of iOS apps provisioned through Systems Manager that are found in the App Store?
- A. Create a security policy that enables automatic updates.
- B. Create a profile with automatic update enabled and apply it to iOS devices.
- C. No configuration step is necessary; automatic updating is the default behavior.
- D. Configure automatic updating of iOS devices in the Meraki installed profile.
Answer: A
NEW QUESTION 33
Which Meraki Dashboard menu section is accessed to enable Sentry enrollment on an SSID?
- A. Wireless > Configure > Firewall & Traffic Shaping
- B. Wireless > Configure > Splash page
- C. Wireless > Configure > SSIDs
- D. Wireless > Configure > Access Control
Answer: D
NEW QUESTION 34
Refer to the exhibit.
The VPN concentrator is experiencing issues. Which action should be taken to ensure a stable environment?
- A. Add a deny any/any firewall rule to the end of the firewall rules.
- B. Physically disconnect all LAN ports.
- C. Remove the connection from Internet 1.
- D. Configure the MX appliance to Routed mode on the Addressing & VLANS page.
Answer: B
NEW QUESTION 35
A customer wants to use Microsoft Azure to host corporate application servers.
Which feature does the customer get by using a vMX appliance rather than connecting directly to Azure by VPN?
- A. next-generation firewall
- B. SD-WAN
- C. malware protection
- D. intrusion prevention
Answer: A
NEW QUESTION 36
What is the best practice Systems Manager enrollment method when deploying corporate-owned iOS devices?
- A. manual
- B. DEP
- C. Sentry enrollment
- D. Apple Configurator
Answer: D
NEW QUESTION 37
Which design requirement is met by implementing syslog versus SNMP?
- A. when automation capabilities are needed
- B. when organization-wide information must be collected
- C. when information such as flows and client connectivity must be gathered
- D. when proactive alerts for critical events must be generated
Answer: C
Explanation:
Reference:
Meraki_Device_Reporting_-_Syslog%2C_SNMP%2C_and_API
NEW QUESTION 38
......
Download Free Cisco 500-220 Real Exam Questions: https://certification-questions.pdfvce.com/Cisco/500-220-exam-pdf-dumps.html